Table of Contents
Advertisement
Specifications
Reel construction
Dethatching range
Blade diameter
Power
Reel bearings
Roller adjustment
Important
Traction unit must be equipped with 27" Lift Arms, Model 03220 to accommodate 27" verticutting reels
Set–Up
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Pivot pin
Spacer
O–ring
CE Decal
Operator's manual
Parts catalog
Registration Card
Blades and spacers bolted to square shaft
Up to 1/4 in. (6mm) deep blade penetration
7–1/4 in. (18.4cm)
Hydraulic motor splined to reel shaft
Self aligning, roller ball type with cast housing
Front roller fixed. Rear roller adjustable
Qty.
Use
1
For use on Reelmaster 3100 traction units with
1
serial numbers of 210000001 or lower
1
For use with reel motor bearing housing
1
Affix to cutting unit for CE.
1
Read before operating.
1
1
Fill out and return to Toro
4
Advertisement
Table of Contents
