3Com Baseline 2816 User Manual page 51

If the firmware image becomes corrupted, you need to
upgrade the firmware. The Switch goes into Fail Safe
mode, and the page shown in Figure 31 displays.
Figure 31 Fail Safe Mode Page
f
To upgrade the firmware, click Browse, and follow the
on-screen instructions to upgrade the Switch to the
required version of firmware.
Alternatively, click RESET to return the Switch to its
factory default settings.
CAUTION: Before recovering the Switch, save the
Switch's current configuration. Recovering the Switch
will cause the current configuration to be lost.
You forget the Switch's default IP address, or you
forget the User Name or Password that you
assigned to the Switch.
The Discovery application can be used for detecting the
Switch on the network. Otherwise, you can restore the
default settings, using the recovery button on the rear
panel of the Switch.
For details on how to use Discovery to detect the Switch
on the network, refer to "Running the Discovery
Application" on page 21.
You must recover the Switch, using the recovery button
on the rear panel of the Switch.
CAUTION: Before recovering the Switch, save the
Switch's current configuration. Recovering the Switch
will cause the current configuration to be lost.
To recover the Switch:
Backup the current configuration. Refer to
1
"Configuration" on page 43 for details.
Turn off the Switch.
2
3 Press and hold in the recovery button on the rear panel
of the Switch using a pointed tool, and then turn on
the Switch. After at least 5 seconds, or when the LED
flashes, release the recovery button. The Switch will
now enter fail safe mode, whereby the Switch's IP
address, user name and password will be reset to the
factory defaults.
Solving LED Issues 51