Audio Control Setting - Kenwood KDC-PS9070R Instruction Manual

Other features

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
2
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
1,2,3
Bass
N-F Phase*
Treble
N-F Low-pass filter*
Balance
Rear High-pass filter*
Fader Front High-pass filter*
1
1,2,3
*
N-F Level* KDC-7070R:
KDC-PS9070R/8070R/8070W:
KDC-PS9070R:
NOTE
Source tone memory
Each source (CD, FM, AM, and disc changer) has its own memory
in which to store the bass, treble and N-F level (KDC-
PS9070R/8070R/8070W) settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
3 Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
1,2,3
1
1
None
2
*
Only when Non-fading is switched on.
3
*
Not available during the Dual zone system on.
Adjustment
mode
4 button
(Display)
Bass ("Bas") Bass decreased.
Treble("Tre")
Treble decreased.
Left channel emphasized.
Balance("Bal")
Rear channel increased.
Fader ("Fad")
Non-Fading Front and rear
Preout Level channels (including
("NF") preout) emphasized.
High-pass You can select the frequency to be cut, as
filter for front follows:
output Through/Throu
("Front / HPF F") 100Hz
You can select the frequency to be cut, as
High-pass
filter for rear follows:
output Through/Throu
("Rear / HPF R") 100Hz
Low-pass filter You can select the frequency to be cut, as
for Non-fading follows:
output 50Hz
("N-FAD / LPF NF")
You can select the phase for non-fading output,
Phase for
Non-fading as follows:
output
Normal (0 )
("Phase / NF Phase")
.....KDC-PS9070R/8070R/8070W
4
Press the AUD button to end the control mode.
NOTE
Setting the high-pass filter
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter works except
during non- fading preout when switching to non-fading.
The factory default settings for front output and rear output are
"Through / Throu".
— 28 —
Operation of Audio control button
¢ button
Bass increased.
Treble increased.
Right channel emphasized.
Front channel increased.
Non-fading sound
emphasized.
40Hz 60Hz 80Hz
120Hz 150Hz 180Hz
40Hz 60Hz 80Hz
120Hz 150Hz 180Hz
80Hz 120Hz Through/Throu
Reverse (180
220Hz
220Hz