Removing The Unit; Locking The Faceplate To The Unit - Kenwood KDC-B7021 Instruction Manual

Removing the Unit

1
Insert the removal tool into the
indentations in the hard rubber
frame, and pull it gently until the
lock is released.
2
Remove the screw (M4×8)
on the back panel.
3
Insert the two removal tools
deeply into the slots on each
side, as shown.
4
Push upward the removal tool
toward the top, and pull out the
unit halfway while pressing
towards the inside.
Be careful to avoid injury from the catch
pins on the removal tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory4
Removal tool
Screw (M4X8)
(commercially available)
Accessory2
Removal tool
— 33 —

Locking the faceplate to the unit

If you want to lock the faceplate to the unit so that it does not fall
off, follow the directions below.
1
Refer to the function "Removing the faceplate" (page 11) and
remove the faceplate.
2
Insert the provided screw into the hole at the center of the
bottom side of the faceplate which you have removed from the
unit.
Accessory5
3
Refer to the section "Removing the faceplate" (page 11) and
then reattaching the faceplate.
Never insert the taptite screws (ø2 X 4 mm) in any other screw holes
than the one specified. If you insert it in another hole, it will contract and
may cause damage to the mechanical parts inside the unit.