Modulation Level/Dynamic Control - Kenwood KDC-C510FM Instruction Manual

Modulation level / Dynamic control
1
To set the control mode
Hold down the RDM button on the
display unit for more than three
seconds.
The LEVEL indicator will light up and
the currently set modulation level will
be displayed.
Modulation level
L E V E L
Number for prevention
of distortion setting
NOTE
• If this function is on, the functions
other than power on / off, reset,
and changing the transmission
frequency, cannot be operated.
• This function is not available when
the random play, repeat play, or
scan play function is on. Before
using this function, cancel the other
functions. This function cannot be
used while loading a disc (while the
play indicator is blinking).
2
To change the modulation level
Press the 4 or 3 button on the
display unit.
20
2
C D A U T O C H A N G E R C O N T R O L L E R
T R A C K
DISC
'
M . R D M D . R E P D . S C N M H z
T R A C K D I S C
4 ¢ -
PWR
Dynamic control "1"
Each time the button is pressed, the
modulation level changes in the range
from 1 to 4. As the number
increases, the modulation level
increases. The initial setting is 2.
NOTE
Dynamic control
The unit comes with the prevention
of distortion function to reduce sound
distortion.
If the sound is distorted severely,
press the + button on the display unit
and then set the function to "2" (ON).
If the prevention of distortion function
is set to "2" (ON), the sound extension
is reduced.
The initial setting is "1" (OFF).
2CAUTION
If a disc with a high recording level is
used, the sound may distort even if the
prevention of distortion function is set
to "2" (ON). In this case, reduce the
modulation level.
To cancel
Hold down the RDM button on the
display unit for more than three
seconds.
The LEVEL indicator will go off and
the modulation level change will take
effect. The control mode is
automatically cancelled if you do
nothing for 15 seconds.
REP
1
RDM
3 8
/
+
Dynamic control "2"