Disc Playback; Playback Procedure - Toshiba D-VR600 Owner's Manual

Disc playback

Playback procedure

NOTES:
• If a non-compatible disc is loaded,
"Incorrect disc", "Wrong region" or
"Wrong Rating" will appear on the
TV screen according to the type of
loaded disc. In this case, check your
disc again (See pages 9 and 22).
• Some discs may take a minute or
so to start playback.
• A prohibition symbol " " may ap-
pear at the upper right of the screen.
This symbol means either the fea-
ture you tried is not available on the
disc, or the DVD/VCR cannot access
the feature at this time. This does
not indicate a problem with the DVD/
VCR.
• When you set a single-faced disc la-
bel downwards (i.e. the wrong way
up) and press PLAY or OPEN/
CLOSE, " " will appear and then
it will change to " ".
• Some playback operations of DVDs
may be intentionally fixed by soft-
ware producers. Since this DVD/
VCR plays DVDs according to the
disc contents the software produc-
ers designed, some playback fea-
tures may not be available. Also re-
fer to the instructions supplied with
the DVDs.
• When playing DTS-encoded Audio
CDs, excessive noise will be heard
from the analog stereo outputs. To
avoid possible damage to the audio
system, the consumer should take
proper precautions when the ana-
log stereo outputs of the DVD/VCR
are connected to an amplification
system.
2K70101A_E P29-36
Preparation:
• Turn ON the TV and set to the video input mode.
• Press DVD to select the DVD mode. (The DVD indicator will light.)
NOTE: It is impossible to switch to the VCR mode while DVD is
played back.
1
Press OPEN/CLOSE.
The disc tray will open.
2
Place a disc onto the disc tray.
Hold the disc, position it with the
printed label side up, align it with the
guide and place it in its proper posi-
tion.
3
Press OPEN/CLOSE to close the
disc tray.
" " appears on the screen and
the disc start playback automati-
cally.
• A menu screen may appear on
the TV screen if the disc has a
menu feature. In this case, press
operate a menu feature.
4
Press PLAY to start playback.
5
Press STOP to end playback.
• The DVD/VCR memorizes the stopped point, depending on
the disc. " " appears on the screen for approx. 4 seconds.
" " keeps blinking in the display window until the playback is
stopped completely. Press PLAY to resume playback (from the
scene point).
• If you press STOP again ("
VCR will clear the stopped point.
6
Press OPEN/CLOSE.
The disc tray opens.
Remove the disc and press ON/STANDBY.
The disc tray closes automatically and DVD/VCR turns off.
29
, , , or ENTER to
" appears on the screen), the DVD/
08`02`07, 20:43
29