Connecting To An Audio System And Tv Equipped With Component Video Inputs - Toshiba SD-4800N Owner's Manual

INTERLACED outputs/inputs (ColorStream
Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,
C , C )
B R
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.

Connecting to an audio system and TV equipped with component video inputs

VIDEO OUT
VIDEO
SELECT
I P
S
To Y To P To P
B R
VIDEO VIDEO VIDEO
OUT OUT OUT
Switching the output signal (interlaced/
progressive) using the remote control
(only when the SELECT (I/P) switch is set to "P")
You can temporarily switch the output signal for better
picture quality.
Press PROGRESSIVE on the remote control.
While the DVD player is outputting progressive signals,
the indicator on the right side on the front panel
illuminates.
Notes
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD
player away from the tuner and radio.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD player's power cord. If you leave the amplifier power on, the
speakers may be damaged.
• The S VIDEO OUT jack and the VIDEO OUT jack cannot output video signals simultaneously, if you select progressive
signal when the SELECT (I/P) switch is set to "P."
®
)
AUDIO OUT
C Ls L ANALOG
Y 5.1CH
SURROUND
BITSTREAM
/PCM
P
B
SUB Rs R
P
R
COAXIAL OPTICAL
R L
2CH
DIGITAL
(red) (white)
To P video input
R
To P video input
B
To Y video input
PROGRESSIVE outputs/inputs (ColorStream
Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal. Connecting to these inputs allows
you to view the highest quality pictures with less flicker.
Audio system
To 2CH AUDIO OUT
(white)
(red)
To audio inputs of the amplifier
TV or monitor equipped
with component video
(INTERLACED) inputs
or
TV or monitor equipped
with component video
(PROGRESSIVE) inputs
* After setting this switch (I/P), be sure to
power off the DVD player then turn it on
to activate the setting.
• Make the following setting.
®
Pro)
Signal flow
To wall outlet
SELECT
Set to "I."
I
P
SELECT
Set to "P."
I P
On-screen display Select:
"Stereo"
"Analog Output"
Page
56
59
19