Wire Routing - Garmin GTN 6 Series Instructions Manual

2.8.4 Wire Routing

The GTN/GMA 35 wiring harness power and
switch connections are routed as shown in Figure
5. Coaxial wire routing may differ slightly from
the depicted since the GTNs may be interfaced
with existing GPS antennas. Refer to the aircraft
wire routing worksheets and equipment location
forms that were filled out during initial GTN/GMA
35 installation for additional details.
GTN/GMA 35 installation racks, backplates with
connectors, and wiring harnesses may be
accessed by either removing the GTN LRUs as
GTN 6XX/7XX PART 27 AML STC
specified in
MAINTENANCE MANUAL
Removal and Replacement or by removing the
side panel of the MD 369 Series console. Figure
6 depicts the installation with the side panel
removed.
190-01007-KB Rev. 3
Instructions for Continued Airworthiness GTN 6XX/7XX - MD369E/F/FF
Section 5, Equipment
Figure 2-6 GTN/GMA 35 Wire
Routing in MD 369E/F/FF
Page 14 of 19