Mitsubishi MDS-A-SVJ Series Parameter Manual page 13

Sets position loop gain during special operation, e.g., with
Normally sets main axis position loop gain.
Set toaether with SVOS~:SHGCSD if SHG control is carried out during
special operation, e.g.. with synchronous tap, main axis C-axis
interpolation.
Set to zero when not in use.
be set to zero.
SV052
Sets excessive error detection range for special operation. e.g.,
OD3
absolute position initial setting or at machine end stopper method.
place when the servo is ON during special operation.
svo54
Sets time in ms from start of deceleration control to application
of dynamic braking.
Normally set to same value as SV056:EMGt.
A setting of zero is taken as an input of 2,000 ms.
Set to 1 if dynamic braking is selected without deceleration con-
trol.
Dynamic braking selection takes precedence over position loop step
stopping.
For axes with brakes, select position loop step stopping or dynamic
braking.
This parameter's time setting must be larger than that of
Sets time taken to stop from maximum rapid traversing speed (RAPID:
axis configuration parameter) following an emergency stop
by an external emergency stop input, insufficient voltage, or
alarm).
From other speeds, deceleration control takes place in direct pro-
portion to the parameter setting.
Normally set to same value as rapid traverse time constant.
A setting of zero sets position loop step stopping.
Reset NC power SUDD~Y after changing RAPID (axis configuration
parameteri.
Set together with SVOO4:PGNZ when SHG control is used.
Set to zero when not in use.
Set together with SVOSO:PGN2sp if SHG control is used during spe-
cial operation, e.g., with synchronous tap, main axis C-axis inter-
wlation.
Must be set to zero.
Must be set to zero.
SV061 Sets output data number of D/A output channel.
Must be set to zero.
SV063 Sets output amplification rate of D/A output channel.
Output amplification rate = setting value / 256.
A setting of zero is taken as a setting value of 256 (output ampli-
fication rate = 1).
SV064 Must be set to zero.
MDS-A-SVJ
Parameter
Description
Descriptions
range
200
999
0
5000
(caused
999
-32768 32767
BNP-B3882B