Table of Contents
Advertisement
8 Settings
"Active/reactive power" menu area
Setting options
Parameter
Mode
F Start
F recovery
Gradient
T recovery
Menu item path
Main Menu > Active/Reactive Pwr > Active Power Ctrl > Power vs. Frequency
Calling up the menu item
1 0 . N o v 2 0 1 9 1 5 : 3 2
S t a t u s :
O n G r i d
P o w e r :
E - T o d a y :
I n v e r t e r I n f o .
G e n e r a l S e t t i n g s
I n s t a l l S e t t i n g s
A c t i v e / R e a c t i v e P w r
F R T
W a r n i n g :
A d j . w o u l d a f f e c t
e n e r g y p r o d u c t i o n .
P a s s w o r d
0 * * *
A c t i v e P o w e r C t r l
R e a c t i v e P o w e r C t r l
P o w e r L i m i t
P o w e r v s . F r e q u e n c y
P ( V )
108
Description
Switch the function on and off.
The grid frequency above which the active power being fed is
reduced.
The grid frequency below which the active power being fed is no lon-
ger reduced.
When the grid frequency exceeds F Start the active power being
fed is continuously reduced by the value specified here.
When the grid frequency falls below F recovery again, the inverter
waits for the time specified here before removing the previously
imposed reduction of fed active power.
1.
When the default information is displayed, press any button to open the main menu.
Otherwise, press the
0 W
0 k W h
2.
Use the
the button
ENT
3.
This function is protected with password 5555.
Use the
Press the
ENT
4.
Use the
the
button.
ENT
5.
Use the
press the
ENT
button repeatedly until the main menu is displayed.
ESC
and
buttons to select the Active/Reactive Pwr entry and then press
.
and
buttons to set the individual numerals.
button to confirm a numeral.
and
buttons to select the Active Power Ctrl entry and then press
and
buttons to select the Power vs. Frequency entry. and then
button.
Installation and Operation Manual for Power Inverter RPI M6A M8A M10A EU V4 EN 2020-07-13
Setting range
ON | OFF
50.00 .. 55.00 Hz
50.00 .. 55.00 Hz
0 .. 100%
0 .. 600 s
Advertisement
Table of Contents
