Adjusting The Motion-Control Levers; Converting To Side Discharge - Toro TimeCutter MX 4275T Operator's Manual

Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3. Tighten both bolts to secure the control lever in
the new position.
4. Repeat the adjustment for the other control lever.
Converting to Side
Discharge
The mower deck and mower blades shipped with the
machine were designed for optimum mulching and
side-discharge performance.
Install the fasteners from the loose parts bag into the
empty holes after removing the recyling baffles.. This
ensures that no holes are left open when operating
the mower deck.
(Figure 11).
Figure 11
(Figure
WARNING
Open holes in the machine expose you and
others to thrown debris that can cause severe
injury.
• Never operate the machine without
hardware mounted in all holes in the
machine housing.
• Install the hardware in the mounting holes
when you remove the mulching baffle.
Machines with 107 cm (42-inch)
Mower Decks
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
g027252
3. Remove the mower deck; refer to
Mower Deck (page
4. Remove the 2 locknuts (5/16 inch) from the
welded posts of the baffle
11).
1. Locknut—5/16 inch (4)
2. Carriage bolt—5/16 x 3/4
inch (2)
5. Remove the 2 carriage bolts and 2 locknuts
securing the baffle to the deck and remove the
baffle
17
50).
(Figure
Figure 12
3. Baffle
4. Welded post (2)
(Figure 12)
ARK
Removing the
12).
g296990