Using Channel Return; Using Surflock; Selecting The Video Input To View - Toshiba 46VX700U Owner's Manual

Using Channel Return

You can switch between two channels without entering
a channel number each time. This feature also works for
external inputs.
1
Select the first channel you want to view.
2
Select a second channel using the Channel Number
buttons (and the dash (=) button if needed).
3
Each time you press
forth between the last two channels that were
tuned.
™

Using SurfLock

™
The SurfLock feature temporarily memorizes one
channel to the button, so you can return to it
quickly, but one time only, from any other channel with
. This feature also works for external inputs.
To memorize a channel to the
1
Tune the channel you want to program into the
button.
2
Press and hold for about 2 seconds until the
message "Memorized" appears. The channel has
been programmed to the
3
You can then change channels repeatedly, and
when you press , the memorized channel will
be tuned.
After pressing and then changing channels again,
the memory is cleared and the button functions as
Channel Return.
Chapter 6: Basic features
, the TV switches back and
button:
button.

Selecting the video input to view

To select the video input to view:
Press + on the remote control or TV control panel.
1
2
Change the input:
Press 0–8.
•
Repeatedly press B or b. Press
•
Repeatedly press +.
•
Inputs
0 ANT/CABLE ANT/CABLE
1 Video 1
2 Video 2
3 ColorStream HD1
HDMI 1
4
REGZA-LINK
5 HDMI 2
6 HDMI 3
7 HDMI 4
8 PC
Note:
• You can label the video input sources according to the
specific devices you have connected to the TV
(- "Labeling video inputs" on p. 30).
• You can skip sources (- "Skipping video inputs" on p.
29).
• Inputs that are set to skip will be not available and will be
skipped over when selecting inputs by repeatedly
pressing + or B or b. They are only available by using
direct number entry.
• If one or more REGZA-LINK
an HDMI input, the REGZA-LINK
input selector. In this case, the label (- p. 30) will not
appear in the input selector.
• When the Auto Input feature is set, you can select a video
input source in the remote control by pressing and
holding the corresponding MODE SELECT button for 2
seconds (- p. 30).
To select a REGZA-LINK ®
1
Press B or b to select a HDMI input.
2
Press c. The list of REGZA-LINK
input appears.
3
If the input has multiple REGZA-LINK
use B or b to select a device.
4
Press .
O K
.
O K
®
devices are connected to
® icon appears in the
device:
® devices for that
®
devices,
33