Cateye PADRONE DIGITAL CC-PA400B Manual page 17

Tap [Pairing]. The paired sensor is displayed under [Device] and pairing is
completed.
* When pairing a sensor with Cateye Cycling™ app, an "A" is displayed after the
sensor name.
7
To perform pairing with another CATEYE sensor, repeat steps
5 and 6.
Perform pairing with the heart rate sensor and all other sensors to be used.
(This does not apply to third party sensors.)
* For the CATEYE sensor signal activation procedure, refer to the
manual.
8
Set the tire circumference for a sensor capable of speed
measurement.
Tap [Device], and then tap [Sensor name] > [Tire Circumference] (the length of the
outer circumference of the tire).
Scroll to find the tire size indicated on the sidewall of the tire. Tap and hold to
choose the tire size.
* Default value: 2096 mm (700x23c)
* The tire circumference must be set for each sensor.
9
If necessary, you can customize the display of the PADRONE
DIGITAL's measurement screen and its total distance value.
For details, see "Capabilities with a smartphone" (Page 30)
10
Close Cateye Cycling™ app or set [Connect] to OFF.
The PADRONE DIGITAL disconnects from the smartphone and switches to a
measurement screen to which the setup details have been applied.
17
sensor's online
Cover,
Introduction
1
2
App
4/4
3
4
SET
5
Appendix