Viewing The Digital Signal Meter; Setting The Time Zone - Toshiba 26C100U1 Owner's Manual

Setting the HDMI
To set the HDMI audio mode:
1無
and open the Sound menu.
Press
2無
Highlight Audio Setup and press
3無
Press p or q to select HDMI 1 Audio and
then press t or u to select the HDMI 1 audio
mode (Auto, Digital, or Analog). (Auto is the
recommended mode.) See "Connecting an HDMI
or DVI device to the HDMI input" ( page 16).
Mode Description
When viewing the HDMI 1 input, if
digital audio from the HDMI input is
Auto available, it will be output. If not, the
TV will automatically detect and output
analog audio from the PC Audio input.
When viewing the HDMI 1 input,
Digital digital audio from the HDMI input will
be output.
When viewing the HDMI 1 input,
Analog analog audio from the PC Audio input
will be output.
4無
To save your settings, highlight Done and press
.
Note: Because the PC and HDMI-1 inputs
share the same set of analog audio inputs, the
PC Audio menu setting influences the HDMI 1
Audio menu setting. If PC Audio is set to "No,"
the HDMI 1 Audio setting changes to "Auto."
If PC Audio is set to "Yes," the HDMI 1 Audio
setting is set to "Digital" and is grayed out in
the menu. (Also see item 3 on page 12 and
"Setting the PC Audio" on page 44.)
26_32C100U1_EN-A5.indb 27
Chapter 5: Setting up your TV
audio mode
®
.

Viewing the digital signal meter

You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1無
and open the Setup menu.
Press
2無
Highlight Installation and press
3無
A new set of Installation menu icons will appear.
Open the Terrestrial menu, highlight Signal
Meter, and press
.
4無
Press pqtu to select the antenna input and
digital channel whose signal you want to check.
Note:
The physical digital channel number listed in
•
the Signal Meter screen may not correspond
to a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
The signal strength does not change between
•
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press
To return to normal viewing:
Press .

Setting the time zone

The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information ( page 50).
To set the time zone:
1無
From the Setup menu, highlight Installation and
press . A new set of Installation menu icons
will appear.
2無
Highlight Time Zone, and press
3無
Press t or u to select the region, highlight Done,
and then press .
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
To set the Daylight Saving Time status:
1無
Press t or u to select Yes or No, highlight Done,
and then press .
.
.
.
27
2010/3/2 上午 11:28:46