Other Regza-Link Functions; Displaying Tv Status Information; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature - Toshiba 19AV600U Owner's Manual

®
Other REGZA-LINK functions
When the Enable REGZA-LINK and each item in the
REGZA-LINK Setup menu are set to On, the following
functions will be enabled.
Item Description
TV Auto If a connected HDMI device starts playing
Input video or audio, the TV will automatically
Switch switch to the appropriate HDMI input.
TV Auto If a REGZA-LINK device is turned on, the
Power TV turns on automatically.
Device If the TV is turned off the TV will send a
Auto message to turn off all of the REGZA-LINK
Standby devices connected to the TV.
From this item, you can set your audio output
preference to the TV speakers or the audio
receiver speakers. When this item is set to
Speaker
Audio Receiver, the TV remote can be used to
Preference
adjust or mute the volume of the audio. This
item will be grayed out unless a REGZA-
LINK compatible audio receiver is connected.
Note: When you turn on the Audio Receiver, change its input
source, or adjust the sound volume, the sound will be output
from the audio receiver's speakers even if TV Speakers has
been selected. Turn the TV off and on again to output the
sound from the TV speakers.
To set the REGZA-LINK
1
From the Setup menu, highlight REGZA-LINK Setup and
press .
2
Press  or  to highlight Enable REGZA-LINK.
3
Press  or  to select On.
Note: If you select Enable REGZA-LINK Off, the other items
will be grayed out.
4
Press  or  to highlight the REGZA-LINK Setup item
you want to use, and press  or  to select On or desired
mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver
•
5
To save the new settings, highlight Done and press
To revert to the factory defaults, highlight Reset and
press .
Chapter 6: Using the TV's features
Setup:
®

Displaying TV status information

To display TV status information using RECALL:
Press on the remote control.
The following information will display (if applicable):
Current input (ANT/CABLE, VIDEO 1, etc.)
•
If ANT/CABLE is the current input, either "CABLE" (for
•
cable TV) or "ANT" (for over-the-air broadcasts).
Channel number (if in ANT/CABLE mode)
•
Channel label (if set)
•
Digital signal strength indicator (bar graph in lower right
•
corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input
•
mode, Dolby Digital or PCM)
Video resolution
•
Aspect ratio of incoming video signal (4:3 or 16:9)
•
V-Chip rating status
•
Game Timer (if set)
•
To close the RECALL screen:
Press again.
To display TV status information using INFO:
Press on the remote control.
The following additional information will display for off air
digital channels (if applicable):
Title
•
Duration
•
Detailed description
•
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing  or  while the RECALL or
INFO display is on-screen.
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately 15
minutes if it is tuned to a vacant channel or a station that completes
its broadcast for the day. This feature functions in ANT/CABLE
.
mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the
TV when the power is resupplied.
Note: If it's possible, and you will be away from the TV for an
extended period of time you should unplug the power cord.
45