Using The Pc Settings Feature; Setting The Pc Audio; Setting The Sleep Timer - Toshiba 19AV600U Owner's Manual

Using the PC settings feature

You can view an image from a PC on the TV screen.
When a PC is connected to the TV's PC IN terminal, you can
use the PC Settings feature to make adjustments to the image.
If the edges of the picture are cut off, readjust the Horizontal
Position and Vertical Position. If the picture is affected by
interference, readjust the Clock Phase and Sampling Clock.
To adjust the PC settings:
1
Repeatedly press to select PC input mode
( "Selecting the video input source to view" page 28).
2
and open the Setup menu.
Press
3
Highlight PC Settings and press
Note: If a PC is not connected or there is no pc input
signal, this feature will be grayed out in the Setup menu.
4
Press or to highlight the item you want to adjust.
 
5
Press or to make the appropriate adjustments.
 
Note: The screen is disrupted momentarily when adjusting
the PC settings. This is not a sign of malfunction.
Mode Description
Horizontal Moves the picture left/right.
Position The adjustment range is within ±50 from center.*
Vertical Moves the picture up/down.
Position The adjustment range is within ±10 from center.*
Helps to reduce noise and sharpen the picture.
Clock Phase
The adjustment range is within ±16 from center.*
Helps to reduce noise and minimize periodic
Sampling
vertical stripes on the screen.
Clock
The adjustment range is within ±10 from center.*
Highlight this item then press
Auto Adjust
optimum adjustment automatically.
The default settings may vary depending on the input signal
*
format.
Chapter 6: Using the TV's features

Setting the PC Audio

This function allows you to output or mute the sound from
your PC when connecting using the PC IN terminal and an
analog RGB cable. ( page 18)
To set the PC Audio:
1
2
3
.

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set
length of time (maximum of 180 minutes).
To set the sleep timer using the remote control:
Press
until the TV turns off. Repeatedly press
time in 10-minute increments, or press
decrease the time in 10-minute increments, to a maximum of
180 minutes.
To set the sleep timer using the on-screen menus:
1
2
3
4
To display the remaining sleep time:
to get an
Press
Note: A message will display on-screen when there is one
minute remaining on the sleep timer.
To cancel the sleep timer:
Repeatedly press
and open the Audio menu.
Press
Highlight Audio Setup and press
to select PC Audio and then press
Press or
 
select No or Yes.
Yes: When viewing the PC input, the audio from the PC
Audio input can be heard.
No: When viewing the PC input, there will be no audio.
Note: Because the PC and HDMI-1 inputs share the
same set of analog audio inputs, the PC Audio menu
setting influences the HDMI 1 Audio menu setting. If PC
Audio is set to "No," the HDMI 1 Audio setting changes
to "Auto." If PC Audio is set to "Yes," the HDMI 1 Audio
setting is set to "Digital" and is grayed out in the menu.
(Also see item 7 on page 11 and "Setting the HDMI™
Audio mode" on page 26.)
on the remote control to set the length of time
and open the Setup menu.
Press
Highlight Sleep Timer and press
Press the Number buttons to enter the length of time in
10-minute increments.
Highlight Done and press
Note: When a power failure occurs, the sleep timer
setting may be cleared.
.
until it is set to 0 minute.
.
or to
 
to increase the
or to increase or
 
.
.
43