Datamax A-Class Mark II Quick Start Manual page 3

This guide presents a systematic overview of important media requirements, setup options, and modes of
use for A-Class Mark II RFID-equipped printers.
 Note:
To use the RFID option, the printer's firmware version must be 12.03 or greater. Downloads can be
found at ftp://ftp.datamax-oneil.com/Printer
Step 1: Know the RFID Media
Ensure that your UHF RFID media meets the following specifications:
Designator
A Label Width
B Label Lengths
C Chip Location Tolerance
D Label Pitch (minimum)
E Chip Inlay Location
[1]
See the Operator's Manual for additional standard media requirements.
[2]
Definitions referenced while looking down onto the labeling side of the media, and from the leading edge of the
label (or tag) in the print direction.
 Note:
If you have questions regarding media selection, contact a Datamax-O'Neil Media Representative at
(407) 523-5650.
Firmware.
Smart Label and Tag Requirements
Layout
C
B
A
Definitions
Description
[1]
Forward
Movement
D
E
[2]
Dimension (inches)
4.00
2.00, 4.00, & 6.00
± 0.05
1.70
1.10
2
Dimension (millimeters)
101.6
50.8, 101.6, & 152.4
± 1.3
57.2
27.9