Table of Contents
Advertisement
Power-on security can be configured to operate with the fingerprint
logon feature. If a fingerprint used for power-on security matches a
fingerprint in an existing passport, the corresponding user is logged
on automatically without having to enter the Windows
password.
NOTE
Your hardware must support Power-on security to use the single
logon feature. You must have administrative privileges to change
settings.
To enable power-on security single logon:
1
Open the Control Center and go to Settings - System
Settings.
2
Check the Allow power-on security single sign-on check box.
(Logon support must be enabled for this option to be
accessible.)
Fingerprint Management
Fingerprints are stored in memory during enrollment. After a
fingerprint is enrolled, it is displayed with a power-on button above
it. The button appears "pressed in" by default, indicating that the
corresponding finger will be used for power-on security. If you do
not want to use a fingerprint for power-on security but only for
logon, click the Boot button to delete the fingerprint from the
fingerprint device memory.
The fingerprint device memory can typically hold up to 21
fingerprints. The number of slots remaining is displayed in the
enrollment wizard.
Fingerprint Authentication Utility
169
Utilities
®
logon
Advertisement
Table of Contents
