Screen Icons - Husky 934 631 Use And Care Manual

Pre-Operation (continued)
– Use to convert angles to different units. Push to change the display units from degrees (°) to pitch
3.
(in/ft) to slope (%). Pitch readings are in 1/8 in/ft increments. Plus and minus signs indicate that the pitch is
slightly more (+) or slightly less (–) than the pitch shown on the display.
4. Reset – Absolute/Relative Angle Conversion button. When the level is turned on, it will be on absolute angle
mode. To change to relative angle, press the Reset button. If you want to use the absolute angle again, turn off
the level and power it on again.
5. LCD Display – The display reads normally when the level is upside down. Once you turn on the tool, the first
display is the temperature (in Fahrenheit). After about two seconds, it will automatically display the absolute
angle in degrees.
6. Working Base – When you lay your digital toolbox level on a flat surface, ensure that its working base is placed
firmly on the working surface.
7. Vial – When using the Digital Level to check level or plumb of the working surface, you can measure the surface
by observing whether the bubble of the vial is in the center. You can use this function without batteries.
8. Battery Compartment – Holds two AAA batteries.
9. Hanging Hole – Hang the tool here for storage purposes.

SCREEN ICONS

Up/Down Indicator – Zero Line (0°) always indicates the level
position. The bias and the right arrow indicate up or down, away
from the level (0°).
Battery Capacity Icon – Indicates the power remaining in
the batteries. Replace batteries if the black power bar has
disappeared.
Beeper Icon – When the beeper function is active, this icon will
appear on the screen.
Hold Icon – When the display reading is frozen, the "H" will blink.