Storage; Storage Safety; Preparing The Machine For Storage - Toro Groundsmaster 3500-G Operator's Manual

Storage

Storage Safety

•
Shut off the engine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Preparing the Machine for
Storage
Important:
Do not use brackish or reclaimed
water to clean the machine.
Preparing the Traction Unit
1. Thoroughly clean the traction unit, the cutting
units, and the engine.
2. Check the tire pressure; refer to
Tire Pressure (page
3. Check all fasteners for looseness; tighten as
necessary.
4. Grease or oil all grease fittings and pivot points;
refer to Greasing the Bearings and Bushings
(page 34).
Note:
Wipe up any excess lubricant.
5. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Note:
Repair any dents in the metal body.
6. Service the battery and cables as follows:
A. Remove the battery terminals from the
battery posts.
Note:
Always disconnect the negative
terminal first and the positive last. Always
connect the positive terminal first and the
negative last.
B. Remove the battery.
C. Slowly recharge the battery before storage
and every 60 days thereafter for 24 hours to
prevent lead sulfation of the battery.
To prevent the battery from freezing, make
sure it is fully charged. The specific gravity
of a fully charged battery is 1.265 to 1.299.
D. Clean the battery, terminals, and posts with
a wire brush and baking-soda solution.
Checking the
42).
E. Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to prevent
corrosion.
F. Store the battery on the shelf or on the
machine in a cool area. Leave the cables
disconnected if you store it on the machine.
55