Table of Contents
Advertisement
Grinding the Cutting Units
You will need to grind the reel edges or bedknife
edges that have become excessively rounded or
distorted. Bedknives that are nearing the end of their
wear life should be replaced. The new blades should
be ground on their holders prior to fitting. When
grinding operations are necessary it is essential that
both the reels and the bedknives are ground at the
same time. The only exception to this rule is when a
new reel is fitted, in which case it is only necessary to
grind the bedknife. All such grinding should be carried
out by your authorized Toro distributor on a quality,
well-maintained reel/bedknife grinding machine
Raising the Mower off the
Ground
WARNING
If you go under the machine while the engine
is running, you could be seriously injured or
killed.
• Never crawl under the machine while the
engine is running.
• Never start the engine while someone is
under the machine.
Important:
Before raising the mower ensure that
the lifting device to be used is in good condition
and capable of supporting the weight of the
mower securely.
Minimum lift capacity: 2,000 kg (4,409 lb)
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the ignition key.
4.
Ensure that the ground under the lifting device
is level and firm.
5.
Align and ensure the lifting device is secure
against one of the lifting points on the machine;
refer to
Locating the Jacking Points (page
6.
If raising the front of the machine, chock the rear
wheels to prevent the machine from rolling away.
Note:
The parking brake operates only on the
front wheels.
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your local regulations.
When disposing of hazardous waste products, take
them to an authorized disposal site. Waste products
must not be allowed to contaminate surface water,
drains, or sewage systems.
Important:
correctly.
Do not dispose of batteries with a separate
collection mark into general waste.
When disposing of hazardous waste products,
take them to an authorized disposal site.
30).
50
Dispose of hazardous substances
Advertisement
Table of Contents
