Toro Top Dresser 1800 Operator's Manual page 17

1. Drive chain
2. Master link
3. Motor
Note: Motor mounting bolts may have to be loosened to
disassemble chain link.
3. Loosen jam nuts and nuts on tension rod to release
spring tension (Fig. 26).
1
2
1. Tension rod
2. Nuts
4. Remove (2) capscrews, washers and nut, on each side of
machine, securing hopper to slider bed (Fig. 27).
1
1.Hopper mounting capscrews
(Right side shown)
5. Pivot hopper rearward and lean against wall, ladder, etc.
Do no allow hopper to rest against rear of machine as
damage may result to brash or hydraulic couplers
(Fig. 28).
Important
center and/or secured to wall or post to prevent it from
accidentally falling on work area (Fig. 28).
3
2
1
6. Loosen (2) capscrews, washers and nut, on right side of
machine, securing slider bed to frame (Fig. 29). Make
sure fasteners are loose enough to allow slider bed to be
tipped.
7. Remove (2) capscrews, washers and nut, on left side of
machine, securing slider bed to frame (Fig. 30).
17
Make sure hopper is pivoted beyond
1
1. Slider bed mounting cap-
screws
2
1. Lifting rod
2. Slider bed mounting capscrews
2
1