Toro Top Dresser 1800 Operator's Manual page 18

8. To remove belt:
Cut belt and remove from rollers
Insert a plastic belt tool between each roller and
belt. Rotate rollers until each tool is positioned to
the outside of each roller. Tool must be inserted past
rib in center of belt.
Insert a lift bar into hole on left side of machine.
Raise lift bar to tip slider bed.
Slide belt and belt tools off the rollers at the same
time.
9. To install belt:
Insert a lift bar into hole on left side of machine and
raise lift bar to tip slider bed (Fig. 30).
Insert belt onto rollers as far as possible.
Insert a plastic belt tool between each roller and
belt. Rotate rollers until each tool is positioned to
the outside of each roller. Tool must be inserted past
rib in center of belt.
Slide belt and belt tools onto rollers until belt is
approximately centered on rollers.
Remove belt tools from between belt and rollers.
Position belt so rib fits into alignment grooves in
each roller.
Reverse procedure to re–assemble hopper and chain
components.
Adjust belt. Refer to Adjusting Conveyor Belt,
page 14.
or
Trouble Shooting
Difficulty in connecting or disconnecting quick
couplers:
Pressure not relieved (Quick coupler under
pressure).
Engine running.
Remote hydraulic valve not placed in float.
Power Steering Hard:
Remote hydraulic valve linkage out of adjustment.
Hydraulic oil level low.
Hydraulic oil hot.
10. Hydraulic leaks:
Fittings loose.
Fitting missing o–ring.
11. Attachment does not function:
Quick couplers not fully engaged.
Quick couplers are interchanged.
Belt Slipping–Check tension.
18