Preparation; Attaching The Stand Unit - Sharp AQUOS LC-60LE841E Operation Manual

Preparation

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
Confirm that there are 11 screws (four long
1
screws, five middle screws and two short
screws) supplied with the stand unit.
Attach the supporting post for the stand unit
2
onto the base using the long screws with a
screwdriver as shown.
Supporting
post
Stand base
Insert the stand into the openings on the bottom
3
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion
Insert and tighten middle screws into the holes
4
on the rear of the TV.
Long screws
Middle screws
5
Attaching the stand cover.
5
Insert the stand cover.
1
Insert and tighten the short screws into the
2
holes of the stand cover.
Short screws
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.
• The TV can be rotated up to 20 degrees to the right and
left.