Preparation; Attaching The Stand Unit - Sharp AQUOS LC-70LE836E Operation Manual

Preparation

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect
installation of the stand may result in the TV falling
over.
Confirm that there are twelve screws (eight long
1
screws and four short screws) supplied with the
stand unit.
Set the supporting post for the stand unit
1
2
onto the polystyrene foam.
Attach the stand base to the supporting
2
post.
Insert and tighten the eight screws into the
3
eight holes on the bottom of the stand base.
• Hold the stand unit securely with one hand, and
then tighten the screws.
Stand base
Supporting post
Insert the stand into the openings on the bottom
3
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Insert and tighten the four screws into the four
4
holes on the rear of the TV.
Short screws
Long screws
TV front
Soft cushion
5
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.