Rear Panel; Function Menu Setup; Microphone; Power - Alinco DX-10 Instruction Manual

(2)FUNC + S/RF
S/RF is the key of TX's or RX's S/RS indicating bar. When this
function is enabled, "SRF"icon would display on the LCD. Repeat
the this operation to key ON/OFF the function.
<Rear Panel>
22.

POWER

Accept13.8V DC power cable with built-in fuse (10 A ) to be
8
connected.
23. EXT SP or PA SP
EXT SP
Accept 4 to 8 ohm, 4 watt external speaker to be connected. When
external speaker is connected to this jack, the built-in speaker is
automatically disconnected.
PA SP
It is used to connect a PA speaker. Before operating PA, you must
firstly connect a PA speaker to this jack.
24. ATTENNA
Accept 50 ohm coaxial cable with a type PL-259 plug to be connected.
CW KEY
25.
This jack is for Morse code operation; To operate, connect a CW
key to this jack and place the MODE switch in the CW position (LCD
display icon "CW").
26. Programming
This jack is for PC program, accept programming cable to be
connected.
<MICROPHONE>
The receiver and transmitter are controlled
b y t h e PTT (Push-To-Talk) key on the

microphone.

Press the key to transmit and then release it to
receive. When transmitting, hold the microphone
two inches from the mouth and speak clearly
in a normal "voice".
1. PTT
Press the PTT (Push-To-Talk) key to transmit.
2. UP/DN
These key allow increasing or decreasing a channel number.
3. MICROPHONE
The radios come complete with impedance 2k ohm microphone.

FUNCTION MENU SETUP

The initial functions and parameter can be changed via the following
settings and operations. Please read the following instruction before
making any desired amendments.
To enter Function Menu: Under ON state, press and hold FUNC key for
more than 2seconds, and then release the FUNC key to enter into the
Function Menu Setup. Under this condition, press FUNC key to select
different functions menu, CHANNEL SELECTOR knob to change the
data of Function Menu.
②
①
③
8 8