Sharp MX-M502N Operation Manual page 571

Specifying the original scan size (Specify using a standard size)
If the original is a non-standard size or you wish to change the scan size, touch the [Original] key to specify the original
size manually. Place the original in the document feeder tray or on the document glass and follow the steps below.
(When a reversing single pass feeder is installed.)
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The automatically detected original size appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
Auto
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
Auto
Manual
Manual
A5
A5R
3
B5
216x340 216x343
Size Input
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 1000 mm (39-3/8") (the maximum height is 297 mm (11-5/8")).
☞
TRANSMITTABLE ORIGINAL SIZES
• To specify an Inch size for the scan size, touch the [AB
Scan/Original
Scan Size
B5
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-53)
OK
100% Send Size
A4 Auto
Image Orientation
(1) (2)
OK
B5R B4
AB
A4 A3
Inch
A4R Long Size
OK
100% Send Size
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
(page 5-17)
Inch] key to highlight the [Inch] side and then specify the scan size.
Touch the [OK] key.
5-56
SCANNER/INTERNET FAX
Contents