Fastening The Inverter To A Flat Surface; Connecting Inverter Cables - Schumacher Electric PI-750 Owner's Manual

4. FASTENING THE INVERTER TO A FLAT SURFACE

For convenience, your inverter can be fastened to a flat surface, horizontally or
vertically. The area where the inverter is to be fastened must be dry, well ventilated
and away from any combustible material or fumes.
1. Turn off and disconnect the inverter.
2. Place the back of the inverter with the mounting bracket against a secure and
flat surface.
3. Attach the inverter to the flat surface using corrosion-resistant screws.

5. CONNECTING INVERTER CABLES

The inverter and power source must be in the OFF mode.
IMPORTANT: Make sure to connect your inverter only to a 12 volt power supply.
INVERTER CONNECTION:
1. Locate the positive and negative plastic terminals on the right side of the
inverter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
CONNECTING INVERTER CABLE TO A VEHICLE (100 watts maximum):
1. Remove the cigarette lighter from its outlet (if applicable).
2. Push the 12 volt power plug firmly into the outlet.
CONNECTING INVERTER CABLES TO 12V BATTERY OR 12V POWER SOURCE:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the positive (red) inverter terminal cable to the power source positive
(+) or battery terminal. Make sure the connection is secure.
4. Connect the negative (black) inverter terminal cable to the power source
negative (-) or battery terminal. Make sure the connection is secure.
5. To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the inverter is being
connected to or disconnected from the 12 volt power source.
CAUTION: Failure to make the correct connections will result in blown fuses and
permanent damage to the inverter.
• 6 •