RIDGID WD10500 Owner's Manual page 5

Caster Assembly
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate Vac
with any parts damaged or missing.
1. Turn the Dust Drum upside down on
the floor.
2. Insert the Caster Feet into the bottom
of Drum, as shown (4 places).
3. Push on the Caster Foot until the Foot
is flush with bottom of the Dust Drum.
4. Insert the Caster Stem into the Socket
of the Caster Foot, as shown
(4 places).
5. Push on the Caster until the Ball on
the Caster Stem is inserted all the way
into the Socket. You will hear the Ball
snap into the Socket and the Caster
will swivel easily when positioning is
correct.
6. Turn the Drum upright.
Carry Handle Assembly
1. Place the Carry Handle on the Wet/
Dry Vac Powerhead Assembly.
2. Tighten both Screws to assemble
the Carry Handle on the Powerhead
Assembly.
5
Caster
Caster
Stem
Caster
Socket
Drum
Screw (2)
Carry
Handle
Powerhead
Power
Assembly
Head
Assembly