RIDGID WD10500 Owner's Manual page 11

Operation (continued)
Blowing Feature
Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the Steps below to use your Vac
as a Blower.
1. Locate the Blowing Port of your
Wet/Dry Vac (Back of Powerhead
Assembly).
2. Insert the Tug-A-Long Dual Flex Hose
into the Blowing Port of the Vac.
The Hose should snap into place.
To remove the Hose from the Vac,
press the Tug-A-Long Dual Flex Hose
Release Button and pull the Hose out
of the Blowing Port.
3. (Optional) Attach the Extension
Wand to swivel end of the Tug-A-
Long Dual Flex Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
4. Turn Vac on and you are ready to use
your Vac as a Blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk
of injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
Powerhead
Assembly
Blowing
Port
TUG-A-LONG WITH
DUAL-FLEX HOSE
RELEASE BUTTON
11
Hose Release
Button
Tug-A-Long with
Dual-Flex Hose
TUG-A-LONG WITH
DUAL-FLEX HOSE
LOCKING BUTTON