10. Adjust the length of the harnesses as shown in the
figure, and clamp the harnesses by the locking clamp.
n
Adjust the length of the harnesses while swinging the
joystick lever from side to side a few times so that the
lever moves smoothly.
Harnesses
RCP-D50
RCP-D51
Locking clamp
11. Tighten the two screws sequentially in accordance
with the figure, and reattach the MB VR plate and lug
terminal to the VR fixed tube.
n
Reattach the lug terminal not to protrude from tip of
the screw.
1
BTP2.6 x 6
MB VR plate
VR fixed tube
12. Perform the steps 1 to 3 in the reverse order.
n
When the adjustment tube does not rotate smoothly in
reattaching the adjustment tube, apply the grease to the
VR fixed tube.
Grease (SGL-601) : 7-651-000-10
Applying value :
About the tip of a cotton swab
Applying area :
Shaded area in the above figure.
13. Perform the Master Black Control Adjustment Value
Calibration. (Refer to Section 1-13-2.)
OK
Lug terminal
NG
Lug terminal
2
BTP2.6 x 6
Lug terminal
10 mm
(all around)
Grease area
2-5 (E)