Sony RCP-D50 Service Manual page 32

5. Disconnect the flexible card wires from the connectors
CN3 and CN4 on the VR-284A board.
6. Remove the four screws, and remove the shield plate
(2) and VR-284A board.
[Note|at|Installation]
When installing the VR-284A board, securely connect the
connector CN2 on the VR-284A board to the connector
CN1 on the LED-407 board.
BTP2.6 x 8
Shield plate (2)
CN4
CN3
2-2 (E)
BTP2.6 x 6
VR-284A board
CN2
CN1
LED-407 board
7. Remove the four screws, and replace the LCD unit.
n
Before reattaching the LCD unit, peel the protection
sheet off the touch panel of the replacement LCD unit.
BTP2.6 x 6
LCD unit
8. Reassemble the parts in the reverse order of removal.
BTP2.6 x 6
Protection
sheet
RCP-D50
RCP-D51