Table of Contents
Advertisement
The user login feature enables the recipient of your message to identify you as the sender by assigning
a username to your message. It also supports query authentication requirements so the query service
knows which user originated a query.
Two-Factor Authentication allows you to address a specific user of the radio when sending messages
so the message is delivered to the user, and not anyone else who may have been using the radio at
the time.
Your user name, unit ID, and password must be provisioned in PremierOne
PremierOne must be linked to an ARS account specifying a token to be used with the Two-Factor
passcode.
You can upgrade the Single Factor session to a Two- Factor session by entering the Two-Factor
passcode only. After an interruption, for example mode change, Dynamic System Resilience (DSR)
switch over, or power loss, the radio is able to restore the active session in its current state as long as
the session is active in the server.
6.14.1.1
Logging in using the Two-Factor Authentication
Procedure:
1 Perform one of the following actions:
•
Press the preprogrammed User Login button.
•
or
to User, and press the Menu Select button directly below User.
The display shows the User Login screen.
2 Perform one of the following actions:
•
or
to [ID Entry] and press the Menu Select button directly below Edit. A
blinking cursor appears. Use the keypad to type or edit a username. Press the Menu Select
button directly below Ok to submit.
•
or
to scroll through the list of predefined usernames. Press the Menu Select button
directly below Sel to select the predefined username.
•
Press and hold
rate. Press the Menu Select button directly below Sel to select the predefined username.
If the selected predefined username has more than the maximum allowed characters, or an
invalid character in it, the display shows momentary Invalid ID.
3 For radio enabled with Unit ID, perform one of the following actions:
•
or
to [UnitID Entry] and press the Menu Select button directly below Edit. A
blinking cursor appears. Use the keypad to type or edit a Unit ID. Press the Menu Select
button directly below Ok to submit.
•
or
to scroll through the list of predefined Unit IDs. Press the Menu Select button
directly below Sel to select the predefined Unit ID.
•
Press and hold
Press the Menu Select button directly below Sel to select the predefined Unit ID.
If the selected predefined Unit ID has more than the maximum allowed characters, or an invalid
character in it, the display shows momentary Invalid UnitID.
4 Enter your password when you see a blinking cursor.
or
to scroll through the list of predefined usernames at a fast scroll
or
to scroll through the list of predefined Unit IDs at a fast scroll rate.
MN003110A01-AJ
Chapter 6: Advanced Features
™
. Your user account in
69
- Quick Links:
- Programmable Features
Hide quick links:
Advertisement
Table of Contents
