Operation - Husky HOTC5218B1QES Use And Care Manual

Operation

1
Locking and unlocking the unit
IMPORTANT : The drawers must be fully closed before
locking / unlocking the unit.
□ Insert the key (K) and turn it fully to the left to lock .
□ Remove the key (K) .
□ Insert the key (K) and turn it fully to the right to unlock .
□ Remove the key (K) .
K
3
Installing the drawers
□ Pull the slides and slide carrier out until fully extended .
□ Hold the slide on the cabinet while aligning it with
the slide on the drawer .
□
Slightly insert one side and repeat for the other side.
□ Slowly push the drawer until it is fully closed to
engage the slide .
□ Open the drawer and close it to verify proper
operation .
2
Removing the drawers
□ Fully extend and empty the drawer .
□ Depending on the slide either lift or lower the
release lever on both sides so the slides can ride over
the stops Pull out to remove
.
4
Preparing the electrical hole
WARNING: Be careful to put the power cord
through the hole, as their may be sharp edges around
the punched hole.
□ A perforated hole is located in the back of the chest to allow
for the use of a power cord to be used while the chest top lid
is closed.
□ The perforated hole can be punched through with a small
hammer, mallet, or punch. The hole has been perforated around
the edges. Take care not to damage the cabinet around the
perforation when punching the hole through.
□ Use a metal file to smooth out any sharp edges around the hole.
8
,
.