To Copy Raw Measurement Data - Agilent Technologies 1660C Series User Manual

To copy raw measurement data

Set up the measurement you want to make, and run the analyzer to
1
acquire data.
For more information on setting up measurements, see the logic analyzer's
User's Guide. You can set up and run the measurement from the analyzer's
X Window interface or front panel, or by programming the analyzer.
Access the logic analyzer's file system.
2
Refer to the chapter "Accessing the Logic Analyzer File System".
Copy the data.raw file from the \slot_a directory for analyzer
3
data, or \slot_b directory for oscilloscope data.
Raw measurement data files are binary format files that can be transferred to
your computer and then reloaded into the logic analyzer later. Because they
are binary files, if you are using ftp to upload or download them, set the type
to binary by typing "bin" at the ftp prompt.
The data.raw file is overwritten each time new data is acquired.
Retrieving and Restoring Data
To copy raw measurement data
4-5