HP 98568A Installation Instruction page 248

HP 7911/7912/7914 Disk/Tape Drives
b. BASIC and Pascal Workstation Recommendations:
• Connect the tape drive to the HP 98625 Disk Interface or to the
built-in HP-IB interface.
4. Set the Disk Address.
a. On the back of the disk drive, find the set of three switches labeled
"HP-IB DISC."
b. Set the HP-IB address:
• If there is only one other disk or tape drive (besides this HP
7911/12/14) already connected to the interface, set the "HP-IB DISC"
switches to 2 as shown in Figure 6-4, unless address 2 has been used
elsewhere.
11 - - ; - - ;
1 •
1
Address 2
Figure 6-4.
Address 2
• If there are two other disk or tape drives (besides this HP 7911/12/14)
already connected to the interface, set the "HP-IB DISC" switches to
3 as shown in Figure 6-5, unless address 2 has been used elsewhere.
Refer to the manual that came with your disk drive if you need
additional switch settings.
6-22 Adding Mass Storage Devices