Infant Car Seat - Baby Trend Snap-N-Go SG88B Instruction Manual

ASSEMBLY
MULTI-POSITION HANDLE
4) • To adjust the handle, press the release
buttons to move it up or down into a
comfortable position for the user (Fig. 4).
NOTE: Make sure the handle clicks into
place before using.
JOY RIDE PLATFORM
WARNING:
are designed to accommodate a child who is at least 2
1/2 years old, has good balance and coordination, and
is not over 36 inches (91.44 cm) tall or 30 lbs (13.6 kg).
• ALWAYS keep your hands on the stroller when your child is standing on the Platform.
• NEVER leave your child unattended while standing on the Joy Ride Platform.
• Make sure your child is always standing with both feet on the Joy Ride Platform.
5) • Attach the Joy Ride Platform: Pull the
locks back on the platform and attach
it to the rear tube of the frame (Fig. 5).
When the platform is not in use, remove
platform.
NOTE: Make sure the platform locks
onto the frame before use. Use caution
while standing on the platform. Make
sure your child is always holding onto
the frame while riding.
7
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Button
The rear platform and jump seat
ATTACHING UNIVERSAL CAR SEAT
ADAPTER
WARNING:
serious injury from falling or
sliding out, always use the
Fig. 4
Infant Car Seat harness.
CAUTION:
serious injury from falling,
always use the safety belt to
secure car seat to stroller.
ONLY
• approved Snap Tech™ products can be
used on the stroller frame.
6) • Attach the Universal Car Seat Adapter by
lining up the anchors on the side of the
car seat adapter with the anchors on the
stroller frame and pushing them together
until they click securely (Fig. 6a).
• Place car seat onto the upper frame with
the Universal Car Seat Adapter Buckle
at the front of the car seat. The car seat
can face in either direction, forward or
backward (Fig 6b).
• Strap the Safety Belts through the Belt
Path on the Car Seat and connect the
buckles together (Fig 6c). Tighten the
strap so it fits snugly and the car seat is
secured to the frame. Tighten the bottom
support straps, located on the back of the
upper frame, by pulling back on the loop
and sliding the adjuster forward for a snug
fit (Fig 6d).
Fig. 5
NOTE: The Safety Belt must be installed
through the Car Seat Belt Path before
using this product.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

INFANT CAR SEAT

Avoid
Avoid
Fig. 6a
Fig. 6b
Fig. 6c
8
Fig. 6d