Infant Car Seat - Baby Trend JG64 Instruction Manual

ASSEMBLY
CHILD TRAY (IF EQUIPPED)
10) • To attach the child tray: Insert the tray
clip into the fitting on the stroller's fold
joint. Check the tray clip locks into
place (Fig. 10a). Push the angled tray
onto the post at the end of the right
armrest, while pressing downward on
the snap button, until locked into place.
Rotate the tray downward until latched
onto the left armrest. Please check that
the snap button comes through and
securely latches the tray in place
(Fig. 10b).
11) • To access the child seat: press inward
on left side tray release button and
rotate upward on the tray (Fig. 11a).
• To remove the child tray: Press the
release button and rotate the tray
180 degrees and pull the tray until it
released (Fig. 11b).
9
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT (IF EQUIPPED)
Fig. 10a
12) • Turn car seat support tabs on the
Fig. 10b
13) • When the infant car seat is locked firmly
Fig. 11a
14) • To remove the Infant Car Seat, squeeze
Fig. 11b

INFANT CAR SEAT

WARNING:
Never
jog or run with your newborn
in the car seat position. Use
for strolling only.
stroller frame (Fig 12a).
NOTE: Check that the front child tray is
firmly attached to the stroller armrests.
• Position the infant car seat so that it
faces toward the rear of the stroller and
the seat shell goes into the front tray
and latches into place (Fig. 12b).
into place, strap the single short clip
over the infant car seat through the seat
belt slots on the infant car seat
(Fig. 13).
IT IS VERY IMPORTANT THAT THE
SHORT CLIP IS ALWAYS TIGHTLY
FASTENED AROUND THE INFANT
CAR SEAT.
the release handle located at the foot-
end of the seat and carefully lift upward
on the seat (Fig. 14).
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 12a
Fig. 12b
Short clip
Fig. 13
Fig. 14
10