Infant Car Seat - Baby Trend JG95C Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

INFANT CAR SEAT

location is intended to prevent the stroller
being tipped backward in the event that
you do fall to the ground. The safety strap
includes a hook and loop attachment for
storage, on the left side of the stroller,
when not in use (Fig. 17b).
INFANT CAR SEAT ATTACHMENT
WARNING:
jog or run with your newborn
in the car seat position. Use
for strolling only.
WARNING:
serious injury from falling
or sliding out, always use
the Infant Car Seat harness.
18) • Fully recline seat back and turn car seat
Support Tabs on the stroller frame
(Fig 18a).
NOTE: Car Seat Support Tabs are Only
used for the infant car seat. Check that
the front child tray is firmly attached to
the stroller armrests.
• Position the infant car seat so that it
faces toward the rear of the stroller and
infant seat is placed into the front tray
and latches into place (Fig. 18b).
• When the infant car seat is locked firmly
into place, strap the single Short Clip
over the infant car seat through the seat
belt slot on the infant car seat (Fig. 18c).
NOTE: It is very important that the Short
Clip is always tightly fastened around
the infant car seat.
11
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Never
Avoid
TO REMOVE INFANT CAR SEAT
19) • To remove the Infant Car Seat,
disengage Short Clip and squeeze the
release handle located at the foot-end of
the seat and carefully lift upward on the
seat (Fig. 19).
TO FOLD STROLLER
WARNING:
Fig. 17b
must be taken when folding
the stroller to prevent finger
entrapment.
CAUTION:
allow children near stroller
while folding.
Fig. 18a
20) • Close the canopy as described in
the canopy section. Recline seat
by releasing buckle as described in
seatback positioning section.
• The stroller is folded by simultaneously
pulling each trigger (Fig. 20a). When the
fold latches are released, the handle will
begin to fall toward the floor. Release
the trigger and press downward on
the stroller handle until the stroller is
completely folded. Secure the stroller
Fig. 18b
in the folded position by locking the fold
latch, located on the right side of the
stroller, over the rivet that protrudes from
the frame (Fig. 20b).
Short clip
Fig. 18c
INFANT CAR SEAT
Care
Do not
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 19
Fig. 20a
Fig. 20b
12

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents