Accessories - Graco 26C624 Instructions Manual

Accessories

Gun Manifolds
Order separately; not included with gun.
(See Parts List - 288048 and 288554, page 28.)
Part No. 241161
North America Manifold
Part No. 241162
International Manifold
Part No. 244930
High Flow Ambient or Temperature Conditioned
Manifold for streaming or spraying.
Grounding Clamp and Wire 222011
High Pressure Ball Valves, Fluoroelastomer
Seals
5000 psi (34 MPa, 345 bar) Maximum Working Pressure
Can be used as fluid drain valve.
Part Description
210657 1/2 npt(m)
210658 3/8 npt(m)
210659 3/8 x1/4 npt(m)
Bleed-type Master Air Valve
250 psi (1.7 MPa, 17 bar) Maximum Working Pressure
Relieves air trapped in the air line between the pump air
inlet and this valve when closed.
Part Description
107141 3/4 npt(m x f) inlet and outlet
107142 1/2 npt(m x f) inlet and outlet
Gasket Filter
Gasket filter 288201, package of 10. Small filter can be
installed in the inlet gasket (3) for added filtration.
Tube Fittings for Air or Water
250 psi (1.7 MPa, 17 bar) Maximum Working Pressure
160° F (71° C) temperature rating
Part Length
104172 1/8 npt(m) x 1/4 OD tube
597151 1/8 npt(m) x 1/4 OD tube, 90° elbow (swivel)
311053L
Filter Kit
Consists of just the filter element
Filter 60 mesh, qty. 25 - 238564
Filter 60 mesh, qty. 3 - 238563
Filter 100 mesh, qty. 25 - 238562
Filter 100 mesh, qty. 3 - 238561
Brush 101892
For cleaning the gun.
In-line Fluid Filter
6150 psi (42.4 MPa, 424 bar) Maximum Working
Pressure Fits onto the gun fluid connector. 1/4-18 npsm
Part Description
210500 100 mesh. Includes the parts shown below.
Consists of filter element 205264.
26C633 60 mesh. Consists of filter element 205265.
210501
Needle/Diffuser Options
Needles must be used only with the specified seat to
guarantee proper seating and life.
• Standard viscosity/standard flow
- Fluid Needle 24B916, 3/16 in. carbide ball
- Seat 288196
• Acid catalyzed materials/very low viscosity
materials
- Fluid Needle 241468, 3/16 in. plastic ball
- Seat 288196
Temperature Sensor and Cable
For temperature conditioned manifold
Part Length
198457 RTD Sensor, 100 ohm, 1/8 npt(m) with 3 pin
Picofast connector
198458 RTD cable, 6 ft. (1.83 m) Flex cable to St.
Clair connector
XHD RAC Guard, SST XHD003
Accessories
168517
205264 (100 mesh)
or 205265 (60 mesh)
33