Battery Charge - PROEL Sagitter BATI 4DL-H User Manual

4x12 wireless / wifi battery projector
Table of Contents

Advertisement

Available languages

Available languages

1.1 CHARGE WITH CONNECTION TO THE MAINS
- Connect the projector to the mains with the Power cable included
- DURING THE COMPLETE PROCESS OF BATTERIES CHARGE THE PROJECTOR MUST BE OFF
- The standard time for battery charge when the level is 5%, is approximately 6 hours
- During the charge, bottom reference LED is RED. When the charge is finished, or when the
projector works only with the battery, this led is green:
Bottom LED RED =
Bottom LED GREEN =
1.2 CHARGE WITH FLIGHT CASE
- DURING THE COMPLETE PROCESS OF BATTERIES CHARGE THE UPPER COVER OF THE FLIGHT
CASE MUST BE ALWAYS OPEN
- DURING THE COMPLETE PROCESS OF BATTERIES CHARGE THE FLIGHT CASE HAVE TO BE
RAISED FROM THE FLOOR (WHEELS INSTALLED), IN ORDER TO ENSURE A CORRECT FLOW OF
FRESH AIR.
- DURING THE COMPLETE PROCESS OF BATTERIES CHARGE THE PROJECTORS MUST BE
ALWAYS OFF.
- THE FLIGHT CASE IS SUPPLIED WITH AN ON/OFF SWITCH SYSTEM THAT DISCONNECT THE
POWER SUPPLY IN CASE OF COVER OF CASE CLOSED DURING THE CARGE OF THE BATTERIES.
THIS CHARGE WILL RESTART WHEN THE COVER OF THE FLIGHT CASE WILL BE OPENED AGAIN.
- PUT THE PROJECTORS IN THE CASE, WITH LEDS ON THE BOTTOM AND THE CONNECTORS ON
THE TOP
- CONNECT THE INTERNAL CABLES OF THE FLOGHT CASE TO EACH PROJECTOR IN CHARGE
- CONNECT THE FLIGHT CASE TO THE MAINS
For correct use of the battery it is strongly recommended to:
-
Charge the battery at least one time each month
-
The minimum level of the charge must be not less than 5%
4. – BATTERY CHARGE
- projector in charge connected to the mains
- if connected to the mains the charge is complete
- If not connected to the mains the projector is supplied from
the battery
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sg bati4dlhSbati4dlh

Table of Contents