Table of Contents
Advertisement
44
en | Installing the Roof Parapet and Pipe Mounts
6.
7.
Warning!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
!
damage or serious injury or death.
10.5
Wire the Pipe Interface Board
This section provides instructions for connecting wires and cables to the Pipe Interface Board,
as illustrated below. Refer to the Connection, page 52 chapter for cable and wiring
recommendations and specifications.
Figure 10.6: Pipe Interface Board Connections
2020-07 | 1.0 |
Apply the supplied thread sealant to the threads on the Pipe.
Make sure all surfaces are clean and dry.
Apply a bead of sealant completely around the leading threads of the male fitting.
Force the adhesive into the threads to thoroughly fill all voids.
Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks.
BNC
6
5
4
3
2
1
7
6
5
4
AGND
OUT 3
3
OUT 2
OUT 1
2
1
3
2
1
2
1
Installation Manual (pendant)
AUTODOME inteox 7000i - 2MP (pendant)
Bosch Security Systems
Advertisement
Table of Contents
