Working Procedures; Sanding Surfaces; Maintenance And Cleaning; Disposal - Parkside PEXS 270 C3 Translation Of The Original Instructions

Working procedures

■ Wait until the power tool has come to a standstill
before putting it down .

Sanding surfaces

♦ Turn on the power tool and ensure that the
whole grinding surface is in contact with the
material being worked . Move it with moderate
pressure over the workpiece .
NOTE
► The removal rate and the sanding pattern are
mainly determined by the choice of sanding
sheet and the contact pressure . Only flawless
sanding sheets achieve good sanding results .
♦ Ensure that you apply even pressure . Use of
excessive pressure does not lead to a greater
sanding efficiency, but rather to increased wear
of the sanding sheet .
♦ Do not use a sanding sheet that has been used
for metal on other materials .

Maintenance and cleaning

The random orbital sander is maintenance-free .
■ Always clean the tool directly after completion
of work .
■ Use a dry cloth to clean the housing . Under no
circumstances should you use fuel, detergents,
solvents or abrasive cleaners .
■ Ensure ventilation openings are always free .
■ Remove any adhering grinding dust with a
brush .
PEXS 270 C3

Disposal

The packaging is made from environ-
mentally friendly material which can be
disposed of at your local recycling
plant .
Do not dispose of power tools in
the normal domestic waste!
In accordance with European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and its integration into nation-
al law, used power tools must be disposed of sepa-
rately and recycled in an environmentally friendly
manner .
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out tool .
Dispose of the packaging in an envi-
ronmentally friendly manner . Note the
labelling on the packaging and sepa-
rate the packaging material compo-
nents for disposal if necessary . The packaging
material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites .
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product .
GB │ IE │ NI │ 7 ■