Toyota HIACE 2006 Owner's Manual page 207

Oil identification marks
Either or both API registered marks are
added to some oil containers to help
you select the oil you should use.
The API Service Symbol is located any-
where on the outside of the container.
The top portion of the label shows the oil
quality by API (American Petroleum Insti-
tute) designations such as SM. The center
portion of the label shows the SAE viscos-
ity grade such as SAE 1 DW-3D. "Energy-
Conserving" shown in the lower portion,
indicates that the oil has fuel-saving ca-
pabilities.
The ILSAC (International Lubricant Stan-
dardization and Approval Committee) Certi-
fication Mark is displayed on the front of
the container.
Diesel engine-
"Toyota Genuine Motor Oil" is used in
your Toyota vehicle. Use Toyota approved
"Toyota Genuine Motor Oil" or equivalent
to satisfy the following grade and
viscosity.
Oil grade:
G-DLD-1, API CF-4, API CF or ACEA
81
198
Recommended viscosity (SAE):
I
20W-50
)
15W-40
')
10W-30
)
1"-
5W-3D Preferred
)
'C-29 -18 -7
4 16 27 38
'F -20
0 20 40 60 80
100
Temperature range anticipated before
next oil change
OILOOl
SAE 5W-30 is the best choice for your
vehicle, for good fuel economy and
good starting in cold weather.
If you use SAE 10W-30 or a higher
viscosity engine oil in extremely low
temperatures, the engine may become
difficult to start, so SAE 5W-30 engine
oil is recommended.
IIDLD-
1
11
OLD logo mark
The Global DLD-1 logo mark, attached
on some oil containers to help in se-
lecting the oil you should use, indicates
that the oil meets the gUidelines recom-
mended by the following associations:
o ACEA (Association des
Constructeurs Europeens
d' Automobiles)
o AAM (Alliance of Automobile
Manufacturers)
o EMA (Engine Manufacturers
Association)
o JAMA (Japan Automobile
Manufacturers Association)