Troubleshooting - Samsung DVD-1080P7 User Manual

Troubleshooting

Before requesting service (troubleshooting), please check the following.
Problem
• Check the batteries in the remote control.
No operations can be
• Operate the remote control at a distance of no more than 20 feet.
performed with the
• Remove batteries and hold down one or more buttons for several minutes to drain
remote control.
• Ensure that the disc is installed with the label side facing up.
Disc does not play.
• Check the region number of the DVD.
• 5. 1 channel sound is reproduced only when the following conditions are met. :
5.1 channel sound is
not being reproduced.
• Check whether the disc being played has the "5.1 ch" mark on the outside.
• Check if your audio system is connected and working properly.
• In a SETUP Menu, is the Audio Output set to Bitstream?
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
The icon appears
2. The DVD's software doesn't support the feature (e.g., angles).
on screen.
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of range.
Disc Menu doesn't appear.
• Check if the disc has a Menu.
• Some of the functions selected in the Setup Menu may not work properly if the
Play mode differs from the
Setup Menu selection.
The screen ratio
• The Screen Ratio is fixed on your DVDs.
cannot be changed.
• Make sure you have selected the correct Digital Output in the Audio Options
No audio.
• Press the
The screen is blocked
• Press the
Forgot password
• Go to the contents and find the section of the instruction book that contains the
If you experience
other problems.
• If the problem still cannot be solved, please contact your nearest authorized ser-
• Make sure that the disc is not dirty or scratched.
The picture is noisy or
distorted • Clean the disc.
• Check the Video output is HDMI enabled.
No HDMI output.
• Check the connection between the TV and the HDMI jack of DVD player.
• See if the TV supports this 480p/576p/720p/1080i/1080p DVD player.
• If snow noise appears on the screen, it means that TV does not support HDCP
Abnormal HDMI output
screen.
• Check your TV system setup correctly.
HDMI output Jitter
• The screen Jitter phenomenon may occur when frame rate is converted from
• Please refer to the user's manual of your TV.
They may need replacing.
the microprocessor inside the remote control to reset it. Reinstall batteries and try
to operate the remote control again.
1) The DVD player is connected with the proper Amplifier
2) The disc is recorded with 5.1 channel sound.
disc is not encoded with the corresponding function.
Menu.
button (in front panel) for more than 5 seconds under no disc
inside. All settings will revert to the factory settings.
button (in front panel) for more than 5 seconds
under no disc inside. All settings including the password will revert to the factory
settings. Don't use this unless absolutely necessary.
explanations regarding the current problem, and follow the procedure once again.
vice center.
(High-bandwidth Digital Content Protection).
50Hz to 60Hz for 720P/1080i/1080p HDMI (High Definition Multimedia Interface)
Output.
Action
Page
P3
P5
P14-15
P27~28
P26~31
P28~29
P27~28
P16
P30
P2
P13~14
P13~14
P28~29
33