Selecting The Cassette Type; Selecting The Recording Speed; Nicam; Switching Between The Tv And Vcr Modes - Samsung SV-DVD1E Instruction Manual

01274A SV-DVD1E/XEU-GB2 9/5/56 7:54 AM Page 24

Selecting the Cassette Type

GB
USER SET
E N T E R E N D :S E T U P
O S D : O N
TAPE SELECT : E 1 8 0
COLOUR SYSTEM : A U T O
I P C : O N
N I C A M : O N
RECORD SOURCE : A U T O
E N D :S E T U P

Selecting the Recording Speed

Type Recording Time (in SP)
E-180 180 mins. or 3 hours
E-240 240 mins. or 4 hours
E-260 260 mins. or
4 hours and 20 mins.
E-300 300 mins. or 5 hours
24
If you wish to use the tape counter to display the time remaining on
a cassette, you must indicate the type of cassette inserted.
1
Press SETUP on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding , or , buttons to select the
USER SET option.
3 Press the ENTER button to select this option.
4 Press the corresponding or buttons, until the cursor is placed
in front of the TAPE SELECT option.
5 Press the or buttons as many times as required, until the
correct cassette length is displayed.
E180 E240
E 300 E260
6
Press SETUP twice to exit the menu.
You can record a cassette at two different speeds:
SP (Standard Play)
LP (Long Play)
In Long Play modes:
Each cassette lasts twice as long
The recording is of a slightly lower quality
To record a cassette... Press the SPEED button on the
remote control, until...
In standard play mode is displayed.
S P
In long play mode is displayed.
L P

NICAM

NICAM programmes are divided into 3 types. NICAM Stereo,
NICAM Mono and Bilingual (transmission in another language).
NICAM programmes are always accompanied by a standard mono
sound broadcast and you can select the desired sound.
Please refer to page 35.
1 Press SETUP on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding , or , buttons to select the
USER SET option.
3
Press the ENTER button to select this option.
Result: The USER SET menu is displayed.
4 Press the corresponding or buttons, until the cursor is
placed in front of the N I C A M option.
5
To... Press or , until...
Mono mode O F F is displayed.
OFF: Only set at this position to record the
standard mono sound during a
NICAM broadcast if the stereo sound
is distorted due to inferior reception
conditions.
NICAM mode O N is displayed.
ON: Normally set at this position.
6
On completion, press SETUP twice to exit the menu.

Switching between the TV and VCR Modes

The TV/VCR button allows you to record one channel with the VCR
while you watch another channel on the TV.
Your television...
On The television receives the picture from
the VCR and you can select channels
with the PROG ( or
VCR or the remote control.
Off (or the VCR is turned off) The television receives the picture from
your home aerial or cable television
system as it did before you connected
the VCR.
You can then use the programme (
) buttons on your television to select
the channels.
USER SET
E N T E R E N D :S E T U P
O S D : O N
TAPE SELECT : E 1 8 0
COLOUR SYSTEM : A U T O
I P C : O N
N I C A M : O N
RECORD SOURCE : A U T O
E N D :S E T U P
) buttons on the
or
25
GB