Led Light; Replacing Carbon Brushes; Maintenance - Clarke DWS180 Operation & Maintenance Instructions Manual

LED LIGHT

1. Adjust light to appropriate angle
2. The light has an independent On/
Off button.

REPLACING CARBON BRUSHES

Both carbon brushes need replacing
once either have less than 6mm
length of carbon remaining.
1. Ensure the sander is switched off
and the plug is removed from the
socket.
2. Unscrew the plastic caps (1&2)
found towards the rear of the
motor housing on both sides. Be
careful as the caps are spring
loaded.
3. Withdraw the brush with its spring.
4. If replacement is necessary,
renew the brush and replace the
cap.
5. Ensure the cap screws back freely

MAINTENANCE

• ALWAYS inspect the sander before use and ensure it is in working
condition.
• Ensure all air vents are clear. (Use vacuum cleaner to clean the
machine where possible).
• Check the power cable to ensure it is sound and free from cracks,
bare wires etc. Avoid using solvents when cleaning plastic parts,
(most plastics are susceptible to damage from the various types of
commercial solvents).
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
12