Inserting The Batteries In The Remote Control; Installing The Display On The Wall Attachment Panel - Samsung PS-42P2SB Owner's Instructions Manual

Inserting the Batteries in the Remote Control

You must insert or replace the batteries in the remote control when
you:
Purchase the PDP
Find that the remote control is no longer operating
correctly
1
Remove the cover on the rear of the remote control by pressing
the symbol downwards and then pulling firmly to remove it.
2
Insert two R03, UM4, "AAA" 1.5V or equivalent batteries taking
care to respect the polarities:
- on the battery against - on the remote control
+ on the battery against + on the remote control
3
Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
Do not mix battery types, i.e. alkaline and manganese.

Installing the Display on the Wall Attachment Panel

Wall attachment panel is sold separately. Check with your dealer.
Installation Notes
Do not install the PDP on any place other than vertical walls.
To protect the performance of the PDP and prevent troubles, avoid the
followings:
- Do not install next to smoke and fire detectors.
- Do not install in an area subjected to vibration or high voltage.
- Do not install on the wall.
- Do not install near or around any heating apparatus.
Use only recommended parts and components.
continued...
9
ENG