3Dγ Adjustment; Memory - Sony VPL-FX51 Service Manual

Hide thumbs Also See for VPL-FX51:
Table of Contents

Advertisement

2-8-4. 3Dγ Adjustment
1. To begin with, enter [GAMMA].
2. Set the LEVEL to 1.
3. Observe how the grade of uniformity of the screen
may be and check undesirable portion.
4. Finding possibly un-uniformity, locate the cursor using
and changing [POSITION] as 1, 2, and 3 back and
forth to the place where to adjust uniformity.
5. Moving [R] and [B] up and down, achieve its unifor-
mity to the extent of satisfactory.
6. Repeat adjustments alike on the LEVEL 2 through 6 as
well.
7. Again, observe each the test pattern of the LEVEL 1
through 6.
Finished completely by now, return to the menu 1
layer back " DEVICE ADJUST " .Then save data in
the " SAVE TO MEMORY ".
Notes:
1. Do not adjust for GREEN, adjust with RED and
BLUE.
2. Do not adjust for levels 0 and 7.
3. Should such adjustments be hardly unavailable and
therefore, want to abandon it to Factory adjust, turn the
power source to "OFF" before SAVE TO MEMORY
of saving data. Data will return to the value default;
the Factory data.
If, oppositely, should enter to execute SAVE TO
MEMORY, data will not return to the default, unable
Factory to adjust.
Therefore, when saving data after any adjusting
performances, take full care of observation on the
screen.
4. When a case is zoom lens, uniformity is somewhat
dependent to the zooming position. Furthermore, it is
possibly influenced by F Number of the lens.
Due to these reasons, suggest adjustments be done
under the projector system same as the usual operating
conditions.
5. Do not use the menu DEVICE ADJUST for any items
other than 3Dγ Adjust.
This DEVICE ADJUST item is comprised of parameters
important to operation of a device. Troubles such that no
picture appears, or the picture clashes will be produced.
Moreover, data of the DEVICE ADJUST item is
unable to be reset in the factory.
If " SAVE TO MEMORY " should be executed, data
will completely changed to otherwise. Never take
redundant operation to change data.
VPL-FX51

2-9. Memory

This model is composed of the following six Memory
blocks.
1. Set memory.
2. Status memory.
3. Channel memory.
4. Chroma memory.
5. W/B memory.
6. Installation memory.
Gamma memory is realized in the gamma mode added by
OFF SET function of the Contrast / Brightness output
value to each device.
For your reference, data stream will be briefed as the
follows.
When plugged in first (Standby state), whole data in the
ROM are written in the NVM (Non volatile memory).
Turning Power to ON, memory data required enough for
current video image are selected from each Memory block
and developed in the RAM where adjusting is performed.
Thus, data adjusted in the RAM are written and memorized
in the NVM, automatically when in the user mode, or
triggered by memory operation.
W / B and Device Adjust is adjusted by an user in the
factory mode and memorized in NVM at performing
memory operation. In this moment any data adjusted in the
factory will be lost.
2-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm-pjm16

Table of Contents