Advertisement
Quick Links
(MTBX22, MTBX30, MTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48)
Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional).
A
A2
Step 1: Screw 4 feet (F) into base (B) leg
ends.
STEP 4: Next place the cylinder (C) over the
exposed metal rod (E).
Square/Round Table Top InSTRuCTIOnS
Two people are required for assembly.
Step 2: Remove the nut from rod (E) and
set aside.
STEP 5: Place the exposed end of the metal
rod (E) through the hole in the spider (D) and
twist the second nut back onto the rod until
tight
B
C
E
D
Step 3: Insert the rod(E) through the hole in
the base (B) and attach nut to exposed rod
end under base bottom.
The product
should now look
like the example
to the right.
A. Square Top
F
A2. Round Top
B. Large Base
G
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
Advertisement
Related Manuals for Regency MTBX22
Summary of Contents for Regency MTBX22
- Page 1 Square/Round Table Top InSTRuCTIOnS (MTBX22, MTBX30, MTBX36, TTSQ3030, TTSQ3636, TTSQ4242, TTSQ4848, TTRD30, TTRD36, TTRD42, TTRD48) Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional). Two people are required for assembly. A. Square Top A2.
- Page 2 Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line. STEP 7: Turn Table upside down. According to your table top(Square or Round) draw 2 diagonal lines across the table as shown below. STEP 8: Place dot 1, located on the template, directly over the crossing lines.
-
Page 3: Important Notice
Remove all wrapping materials, including staples & packing straps before you start to assemble. Do not tighten all screws/bolts until completely assembled. Keep all hardware parts out of reach of children. Any problems or questions please call Regency Office Furniture at 1-866-816-9822... - Page 4 -The Outside dots are for 48” Table tops and MTBX 36 X-Bases. -The Inside dots are for 30”, 36” and 42” Table tops and MTBX 22 & 30 X-Bases. LINE UP TOP EDGE OF SECOND SHEET HERE.